Face Gears and Splines

 

Face Gears

HyGEAR supports Face Gears, with or without offset and helix angle. The pinion member may be cut by a rack or shaper, while the gear is cut by a shaper. Tooth flank coordinates, bending strength and contact stresses can be obtained while including misalignment effects on load distribution.

 

 

 

Involute Splines

HyGEARS supports involute splines. The tooth flank coordinates, bending strength and contact stresses can be obtained easily, while including misalignment effects on load distribution.

The left figure below shows an external involute spline contacting with its internal counterpart, alternately on the left and right sides of the teeth.The right figure shows a spline with a stub shaft.

 

Cylindrical / Bevel / Hypoid Gear Design, Analysis and Production Control Software
                                                          with 3, 4, 5Axis CnC Gear Manufacturing
HyGEARS™ V 4.0